pic: 1848 finished base

[Synergy1848]

loading photo ...

[Tapoore]

Are the center wheels rubbing against the Toughbox brackets?

[IndySam]

might make it turn better, did you try it?

[Elgin Clock]

Originally Posted by Tapoore

Are the center wheels rubbing against the Toughbox brackets?

With the fullsize pic HERE, it doesn't look like it.
It may when it gets pushed around and starts to "take a beating" though.

Nothing a simple notch into the support plate couldn't remedy.

[Jimmy Nichols]

Is your mounting plate a sheet of aluminum that you drilled or was it purchased?

[Synergy1848]

no, the center wheels don't touch the brackets

Originally Posted by Jimmy Nichols

Is your mounting plate a sheet of aluminum that you drilled or was it purchased?

thats actually silver pegboard.

[jason701802]

you've got the negative running out of the power switch and your not using the power dis. block

[Astarties]

Originally Posted by jason701802

you've got the negative running out of the power switch and your not using the power dis. block

if that's not what your talking about, you may want to look at the diagram that's in the FIRST manual, because jason701802 is right.

[pheadxdll]

A slight flaw in your wiring. Refer to the eletrical wiring diagram in the manual. (I have no idea which manual, hence why I don't have a link ) Drive train looks good though (no shortage of power ). Good luck!

[Synergy1848]

i can't beleive no ones gotten it yet, look at the 2 froint wheels

[T3_1565]

well now that it has been mentioned it looks like the two front wheels aren't in the same spot on the pegboard lol.. the left (left in the picture) wheel is closer to the fron than the right one.

[Jeff Waegelin]

The chain on the left side appears to be dragging on the ground... looks like the chain was too long!

Is that what you were having us look for?

[Uberbots]

You are missing your flux capacitor. you need to remember these things (=

[Ryan Dognaux]

... and it looks like the axles for the wheels aren't in the same places on each side. Looks like you'll be moving one of them.

[BradMello]

Your axles aren't aligned!