|
|
|
 Grease, blood and cookies... it must be build season. - danshaffer [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Grease, blood and cookies... it must be build season. - danshaffer [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Pressure Gauge
I cant seem to find the pressure gauge that hooks up to the pressure switch and the relief valve
the kit only gives two pressure gauges right? If I attached both of them to my main and secondary regulators, does that mean I have to purchase another pressure gauge? also, what is a sub base? what is a gasket? did the kit provide gaskets? Thank you! |
|
#2
25-01-2008, 20:50
|
|||||
|
|||||
|
Re: Pressure Gauge
Look at Page 13 of the pneumatics manual. The only gauges you really are required to have are the two closest to the compressor: One to show the compressor output pressure (located by the relief valve) and one to show the regulated "working" pressure (at the Norgren regulator). The third gauge shown at the Monnier regulator is optional, only of you need both 60 PSI and some other, lower pressure.
Don |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3rd pressure gauge? | Maximus123 | Pneumatics | 1 | 07-02-2007 00:30 |
| Rules about pressure gauge position | Kamen64 | Rules/Strategy | 1 | 06-02-2007 19:15 |
| [OCCRA]: Gauge | JonMTeam255 | OCCRA Q&A | 1 | 24-09-2004 19:01 |
| Translating pressure sensor readout into actual pressure | Mercutio | Pneumatics | 0 | 13-02-2004 16:29 |
| What gauge wires | Punjabguy87 | Electrical | 7 | 07-02-2004 20:25 |
Linear Mode
