|
|
|
 Trapping JVN (or any other IFI employee) is negative infinity [I]and[/I] a caption contest. Trapping 1114 is a measly 50 points, unless you trap Karthik, which multiplies your entire score by -1. - EricH [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Servo shifting a dewalt
Team 1983 is wondering if it would be possible to use one PWM from the robot controller split into four, using sets of y-cables, to shift each of the four transmissions simultaneously using the servos. We are using the "Nothing But Dewalts" system and are looking for ways to make sure each motor/servo will shift at the same time.
Thanks! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AM servo delayed or no shifting | haroony341 | Technical Discussion | 20 | 11-04-2007 12:31 |
| Shifting transmissions: servo or pneumatics? | gnirts | Motors | 8 | 15-01-2007 21:52 |
| paper: Servo Vs. Pneumatic Shifting | GMAdan | Extra Discussion | 1 | 04-12-2006 11:48 |
| Dewalt Shifting Questions | Ben Piecuch | Technical Discussion | 3 | 20-02-2006 13:40 |
| Servo behavior question / advanced servo/PIC programming question | DanL | Electrical | 12 | 18-10-2005 18:33 |
Threaded Mode