|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
||||
|
||||
|
Re: 1458's board
You have to be able to see the lights of the Robot Controller from three feet in front of the robot, and as far as I can tell you can't, but that might just be the angle of the picture. Also you will need to access the programming and tether ports on the controller. Also the reset and program buttons are at bottom and very hard reach.
Other than that, it all looks legal, as long as the wire sizes are correct. You may find that you want to have better access to the bottom victors, for debugging and if one of them dies. -Kit |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| IR Board Fried? | JCODER | Sensors | 23 | 15-02-2008 16:37 |
| IR board | joshuamorris | Electrical | 2 | 12-01-2008 19:43 |
| IR Board? | Pavan Dave | Rules/Strategy | 3 | 06-01-2008 19:10 |
| Lights in Joystick board or control board | rcubes85 | Control System | 15 | 26-02-2005 23:40 |
| Perf Board = BS2-IC Carrier Board? | indieFan | Electrical | 2 | 16-09-2004 08:28 |