Remote board

Mike.Allen · #1 27-01-2008, 14:40

Can anyone give me a diagram to hook up the IR sensor to the RC board?

Mike.Allen · #2 31-01-2008, 15:02

Can anyone help us?

Al Skierkiewicz · #3 31-01-2008, 15:09

Mike,
Full instructions on use and installation and the schematic are on the FIRST website in the additional documentation link under Section 8, I believe.

Mike.Allen · #4 31-01-2008, 15:24

I don't see it. I see a description for the board but not instructions beyond that video that really didn't show the wiring very well

Al Skierkiewicz · #5 31-01-2008, 15:33

http://www.usfirst.org/community/frc...nt.aspx?id=482 for IR board video and schematic.

DanDon · #6 31-01-2008, 15:34

Quote:

Originally Posted by Mike.Allen

I don't see it. I see a description for the board but not instructions beyond that video that really didn't show the wiring very well

The FIRST documentation gives you the pinout of the IR board. One or both of the ground and one or both of the Vcc pins get connected to your ground and supply voltage source respectively. The other pins would get connected to PWM cables going to your digital inputs. All other needed information is in the FIRST documentation.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Remote	sportman3333333	Control System	2	27-01-2008 12:41
Lights in Joystick board or control board	rcubes85	Control System	15	26-02-2005 23:40
Perf Board = BS2-IC Carrier Board?	indieFan	Electrical	2	16-09-2004 08:28
Remote Remote Kickoff for Southern California	ChrisH	Southern California Regional Robotics Forum	0	05-01-2004 12:36
Remote Remote Kick off at University High School	George1902	Off-Season Events	4	04-01-2004 21:05