|
We use Solid Edge, Unigraphics good lookin' step child
Posted by Scott Strickland.
Engineer on team #21, ComBBAT, from Astronaut & Titusville High School and Boeing/NASA.
Posted on 1/28/2000 8:52 PM MST
In Reply to: We use Unigraphics posted by Joe Johnson on 1/27/2000 7:04 PM MST:
We are using Solid Edge again this year. It is made by Unigraphics, uses the same modeling kernel, but is a lot easier to use. We showed our robot (as did team 34) at the Solid Edge User's Group Conference. Dave Brown (FIRST Pres)was the Keynote speaker
Solid Edge has been kind enough to give us temporary licenses for our team's use. I think they would love to be a bigger supporter of FIRST (they sponsored a lego comp. this year).
Our high school students are modeling parts after taking a few tutorials (with no CAD experience). Still, the software is every bit as powerfull as UG if you don't require the use of surfaces. Solids work fine for anything that is machined.
Scott
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
Is Atlanta an Indian word for "take the longest path between two places"? - Klondike Mike [more] 
23-06-2002, 22:52
Similar Threads
Threaded Mode