|
|
|
 When all you're holding is a hammer, every problem looks like a nail. - artdutra04 [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| When all you're holding is a hammer, every problem looks like a nail. - artdutra04 [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Coupling a Globe Motor
How would I couple a globe motor to a sprocket, pulley or gear??
pictures would be nice  Thanks in advance |
|
#2
29-01-2008, 01:01
|
|||||
|
|||||
|
Re: Coupling a Globe Motor
|
|
#3
29-01-2008, 08:26
|
||||
|
||||
|
Re: Coupling a Globe Motor
The globe motor gearbox has a 3/8" diameter shaft, and is fairly long. We have coupled to it two ways.
1) Find a gear with a 3/8" bore, drill and pin the gear to the shaft. 2) The shaft is supported by a single bronze bushing, so it doesn't like large cantilevered loads. We have used a shaft coupling to connect it to second, co-axial shaft, which was either keyed or had a gear pinned to it. 3) The AM adapter (linked to above) looks pretty nice as well. Bengineer |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Nippon-Denson Motor Coupling needed | Stephen P | Motors | 2 | 07-09-2005 22:52 |
| Gear Coupling for Jideco Window Motor | hayakuneko | Motors | 4 | 30-01-2005 18:35 |
| Globe Motor Coupling | MechaJag | Motors | 5 | 24-01-2004 18:12 |
| Motor coupling | archiver | 2001 | 19 | 23-06-2002 23:35 |
| Help! Need Motor Coupling FAST! | Eric Reed | General Forum | 3 | 06-09-2001 00:40 |
Linear Mode
