|
|
|
 We're 30 pounds over LOL. I probably shouldn't be lol'ing, but it is 11:52PM, I just got home from a 15 hour build session, and I find the word 'potato' funny. - ZakuAce [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Simple question regarding OI LED's
One of my programmers was playing with the LED's on the OI board, but was curious.
He put the statement Pwm1_red=1; in the default routine, and the Led did not light up red. I was at a loss as to why it didn't work. So, what's up with this? |
|
#2
29-01-2008, 09:17
|
|||
|
|||
|
Re: Simple question regarding OI LED's
That should work...
If this is happening every loop, either the light is being turned back off or the light doesn't work. Make sure that no other code after that points turns the light back off, and try turning on all the other lights. |
|
#3
29-01-2008, 09:47
|
|||||
|
|||||
|
Re: Simple question regarding OI LED's
The OI feedback LEDs share data space with the user display byte. You can't use them both at the same time. If the OI is showing the user byte, none of the LEDs will light.
|
|
#4
29-01-2008, 12:03
|
||||
|
||||
|
Re: Simple question regarding OI LED's
Aha! That would make sense. It stopped working after we added some code that prints the PMW values of our choice out to the user byte for debug. Thank you!
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| EasyC Question regarding simple program | aeasson | Programming | 6 | 14-01-2008 23:16 |
| Simple question on MPLabs | itsme | Programming | 7 | 20-01-2007 00:05 |
| Quick Simple Question | ImmortalAres | Programming | 8 | 17-06-2005 13:08 |
| simple joystick question | vexingspector | Programming | 5 | 19-02-2005 18:55 |
| simple question... answer it | archiver | 2001 | 1 | 24-06-2002 01:02 |
Linear Mode
