|
|
|
 ANY team is capable of producing a winning design. This does NOT require anything more than brainpower, and time. - Racer26 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| ANY team is capable of producing a winning design. This does NOT require anything more than brainpower, and time. - Racer26 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Best Sprockets
at this point the only way i can see our arm powered is if I use the keyang motor with a small sprocket and a large sprocket attached to the pivot of our arm. I wanted to do a winch with a lever but that seems to be out because of the 80 inch envelope. If there are any other suggestions they would be greatly appreciated. The big question is where should I get the sprockets?
Andymark has some and so does IFI. our team hasn't done anything with chain in years, so i am making it up as i go along... |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Who's the best vendors for getting 25 chain and sprockets? | waialua359 | Kit & Additional Hardware | 5 | 08-01-2008 22:17 |
| sprockets | Adama | Technical Discussion | 12 | 14-01-2007 14:05 |
| Best Matches (best fought not score) | ne0x0n | General Forum | 13 | 01-04-2005 12:40 |
| sprockets | BBFIRSTCHICK | Technical Discussion | 21 | 09-02-2003 01:01 |
| sprockets | Greg Needel | Technical Discussion | 0 | 23-04-2002 12:30 |
Threaded Mode