|
|
|
 It would be a (relatively) level* playing field *...though it seems like the actual field will be anything but level. - Jacob Bendicksen [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It would be a (relatively) level* playing field *...though it seems like the actual field will be anything but level. - Jacob Bendicksen [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: pic: the inventor file
Oh, I didn't realize the need to rotate, so what I said was wrong...sorry!
If the arms only need to rotate over the lift when the lift is in the full up position, then you could connect both sides together with a shaft, and then you would only need one motor. I can not tell enough about your design to know if this would actually work, though. Does the center part slide all the way to the top of the channel? 
|
|
#2
29-01-2008, 16:16
|
||||
|
||||
|
Re: pic: the inventor file
now i see, we thought about it but it wont work with 1 shaft.
what u suggested might work i will check it out! thanks alot!
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to use the data obtain in one C file to another C file? | tommy_chai | Programming | 8 | 11-01-2008 02:17 |
| tank tread inventor file | SgtMillhouse648 | FIRST Tech Challenge | 0 | 14-09-2006 11:12 |
| Huge Inventor File Sizes | Robert Thacker- | Inventor | 8 | 08-04-2006 12:43 |
| Help! making an inventor file into an autodesk file | kjhobin | Inventor | 5 | 19-03-2006 23:04 |
| Inventor File to Powerpoint | yamo18 | Inventor | 5 | 25-01-2004 14:17 |
Hybrid Mode
