IR help

kevin.li.rit · #1 29-01-2008, 20:54

Quote:

Originally Posted by popo308

also you are pulsing voltage into the RC where as connecting the pins is a ground to signal connection... that could be why

What I assume is happening is that the output pins on the PIC on the IR board, is set to 0 which would ground the signal on the RC and give a 0. When it sees the IR pulse it changes the output pin to 1 which is a high 5V. That would give you a 1 in programming.

popo308 · #2 29-01-2008, 20:58

Quote:

Originally Posted by Coffeeism

What I assume is happening is that the output pins on the PIC on the IR board, is set to 0 which would ground the signal on the RC and give a 0. When it sees the IR pulse it changes the output pin to 1 which is a high 5V. That would give you a 1 in programming.

yep exactly

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Grab Frame - Help Help Help...	nmihailidis	Programming	2	04-03-2007 14:44
section 'InterruptVectorLow' type is non-overlay (was: HELP HELP HELP!!!!!)	naor52	Programming	14	24-02-2007 01:19
Help: How do we get a teacher to help? (was: Help)	ChaosAlchimey	General Forum	13	21-01-2007 11:57