|
|
|
 Before you fix something, it's worthwhile to make a concerted effort to figure out why it failed. - Ether [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Before you fix something, it's worthwhile to make a concerted effort to figure out why it failed. - Ether [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
In need of sprockets
Does anyone know where to find sprockets for the taigen (van door) motor?
|
|
#2
29-01-2008, 21:43
|
|||||
|
|||||
|
Re: In need of sprockets
We bought sprockets made for a three eights (3/8") shaft and drilled them out to 11mm or so and then screwed them onto the shaft.
|
|
#3
29-01-2008, 21:59
|
||||
|
||||
|
Re: In need of sprockets
Quote:
|
|
#4
29-01-2008, 22:11
|
|||||
|
|||||
|
Re: In need of sprockets
mcmaster.com or grainger.com has them as for the drill bit i just got a metric caliper measure the shaft to be about 11mm or so and them found a drill bit that was close to 11mm
|
|
#5
29-01-2008, 22:18
|
||||
|
||||
|
Re: In need of sprockets
Quote:
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need more stock sprockets! | GMKlenklen | General Forum | 2 | 30-01-2007 23:29 |
| Sprockets | VinceT | Kit & Additional Hardware | 4 | 18-01-2004 23:07 |
| sprockets | BBFIRSTCHICK | Technical Discussion | 21 | 09-02-2003 01:01 |
| need help fast!!! Hubless 1/4 pitch sprockets | Travis Covington | General Forum | 6 | 03-02-2003 18:44 |
| sprockets | Greg Needel | Technical Discussion | 0 | 23-04-2002 12:30 |
Linear Mode
