|
|
|
 Last year we saved a ton of money by using a good bit of square tubing for the frame of our robot, square tubing is a lot cheaper then C channel. We get to use so much raw material that the cost should go down in certain places. - Derrick Maust [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Controlling Two Robots at Once
Since this is our second year, our team now has two driving robots and two operator interfaces, but we cannot control them both at the same time because the team number on the OI is the same. We turned on one OI, and both robots, and it controlled both of them at the same time, which was not very good.
How do other teams work with this? Do you change your team number just to avoid the interference, or is there another way to change the channel? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Video of FRC488 lifting two robots | Madison | Robot Showcase | 15 | 08-01-2008 16:45 |
| Controlling a Mecanum drive with two joysticks? | Leav | Technical Discussion | 9 | 09-12-2007 19:11 |
| pic: PNW - Semifinal 2.3 - FRC488 lifts two robots. | Madison | Extra Discussion | 0 | 12-06-2007 22:51 |
| two robots | utishpenguin | Rumor Mill | 26 | 03-10-2002 02:57 |
Threaded Mode