|
Drill Motor Output - Fwd vs Rev
Posted by Nate Smith.
Other on team #66, GM Powertrain/Willow Run HS, from Eastern Michigan University and GM Powertrain.
Posted on 1/31/2000 8:24 AM MST
Just thought I'd throw this out there and see if anybody knew the answer before I went to the trouble of figuring it out myself...I'm working on adjusting the drive train of our machine(using the drill motors), so that the differences in the speeds of the motors between forward and reverse are 'scaled out' by the program. I was wondering if anybody had the numbers for roughly what the difference was, so I can incorporate the scaling into my program without taking a lot of time to figure out the differences...I had it close once, but then we found out we were getting extra friction on one motor, so now I'm not even close any more...please, help!
Thanks!
Nate
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
There are so many creative and brilliant minds out there that build wonderful inventions and machines---surely we can be equally creative and open minded ... - Tonya Scott 476 [more] 
Similar Threads
Threaded Mode