|
|
|
 There is a really bad trap most people fall into, when presented with data they tend to trust it. This is dangerous. - Andrew Schreiber [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| There is a really bad trap most people fall into, when presented with data they tend to trust it. This is dangerous. - Andrew Schreiber [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
30-01-2008, 18:39
|
||||
|
||||
|
Re: large cim motors?
ok so if my understanding is correct, 2" cim motors from last year or the year before cannot be used unless they are used as a back up. we have 4 cim motors currently driving our robot (2 from last year and 2 from this year) and we are planning on using one more (from last year or 2 years ago) to lift an arm. is that still not allowed?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| Sprocket on large CIM | s_forbes | Motors | 9 | 29-01-2006 23:01 |
| Large Cim Motor? | Fishdude404 | Motors | 1 | 27-01-2006 22:36 |
| Large CIM | Gary Bonner | Motors | 2 | 24-01-2006 19:57 |
| Large CIM Motors - Removing the sprocket | PuiChi | Motors | 5 | 13-01-2006 16:01 |
Threaded Mode