|
|
|
 Accidents happen, but they can be prevented with just a LITTLE bit of forethought. - AdamC [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Accidents happen, but they can be prevented with just a LITTLE bit of forethought. - AdamC [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
ouble valve, with a center CLOSED port.
double valve, with a center CLOSED port.
It's a 3-position valve. SMC has them in the same series as the kit of part valve, only you need the center closed version. i was looking around and found a post about controling extension on a solonoid to hal way can somone pin point the valve i need on the smc website because there is like 100 difrent types of them so if somone could post a link Thank you i need the valve for a doulbe solonoid so i can make the piston go halfway i need one compatible with the solonoids first gave us thank you |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Playing with the Content Center | KnightOfIvory | Inventor | 1 | 29-01-2006 08:03 |
| Center to Center Distance for 2002 Chaiphua and Cluster gear | sanddrag | Motors | 1 | 20-07-2005 07:36 |
| Powering with the Competition Port | David Bing | Electrical | 4 | 17-03-2003 19:30 |
| Problem with communicating with STAMP through serial port | Skabana159 | Technical Discussion | 2 | 06-02-2003 21:10 |
| trouble with assembling FESTO valve | geo | Pneumatics | 15 | 02-02-2003 09:28 |
Threaded Mode