|
|
|
 Do not interrupt, do not defend yourself - just listen. After they are done, be sure to thank them for their honest feedback, and close the books. Arguing or defending is not how to accept feedback. - DonRotolo [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Crisis Regarding IR Board!!!
Our IR board has been working PERFECTLY until now. We had it all programmed (to recognize commands from remote) and wired. All of a sudden it no longer recognizes the original commands anymore. I will try to put it into program mode and attempt to retrain the board with the first command. I will hold down the button I want to program for the first command and soon the CMD0 light will go out only to be replaced by the error LED flashing approximately 7 times. After this, the CMD2 light will light and remain lit until I power the board down. Furthermore, if I enter program mode and then tap the button on the IR board the error LED will flash and then all four CMD LEDs will light and remain lit until I power the board down.
Is there anyone out there with a solution to this problem? |
|
#2
02-02-2008, 01:52
|
||||
|
||||
|
Re: Crisis Regarding IR Board!!!
Have you tested the 5V regulator? They seem very failure prone and your's might have died.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Few Questions regarding IR board | itsme | Electrical | 3 | 14-01-2008 14:55 |
| Johnson Space Center Crisis | notaPINKtruck | Chit-Chat | 8 | 21-04-2007 12:24 |
| 245 Identity Crisis | MattLi | General Forum | 12 | 15-04-2007 21:03 |
| Bumper crisis...kinda | Hiromi | General Forum | 15 | 14-02-2007 14:21 |
| Compression Crisis | reisser | 3D Animation and Competition | 9 | 22-02-2004 11:23 |
Linear Mode
