IR Remote Programming

[Philz20]

Originally Posted by jacobhurwitz

After you train the IR board (see the manual for details), it's simple. The board uses four digital inputs, and each input is 1 if it's respective trained signal is being received, 0 otherwise.

I forget the exact digital input numbers, though, and I don't have our code right now. (It's in the hallway being tested.)

EDIT: Apparently, the digital input numbers are just the four digital inputs into which you plug the IR board.

I'm pretty sure you read my post wrong. The IR remote is programmed, but I am talking about the actual code as in C.