|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Compresser Wiring Help
I need help in wiring the compresser and the pressure switch so it will work the way it is intended. Me and a few others on my team have a few different ideas on how to wire them but we don't know if any of them will work.
Thanks in advance. |
|
#2
|
|||||
|
|||||
|
Re: Compresser Wiring Help
You have to hook the pressure switch back to the Robot Controller. DO NOT HOOK IT IN SERIES WITH THE COMPRESSOR
Use a PWM Cable cut off the male end and wire the Ground and Signal Wires to the pressure switch (doesn't matter which terminal on the pressure switch). Then you can plug the female end into a digital input on the controller For the Compressor hook it up to a Spike Relay |
|
#3
|
||||
|
||||
|
Re: Compresser Wiring Help
So
compressor > spike and pressure switch > digital in |
|
#4
|
|||||
|
|||||
|
Re: Compresser Wiring Help
correct
Edit: Programming line: relayX_fwd = !rc_dig_inXX; Replace X and XX with the port number Last edited by Gamer930 : 02-02-2008 at 19:18. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help wiring potentiometer-to-Analog port | kylehager | Electrical | 4 | 17-01-2008 17:28 |
| HELP...Wiring Problem | neslo89 | Inventor | 0 | 11-03-2006 09:16 |
| HELP! We need pneumatic wiring help! | BrittanyV | Pneumatics | 13 | 10-03-2006 09:26 |
| Wiring issues, help needed | halomaster69 | Electrical | 7 | 19-02-2005 14:21 |
| Help wiring Line sensors | magical hands | Electrical | 1 | 18-02-2004 10:17 |