|
Lock it in and go!!!
Posted by nuts4first.
Engineer on team #340, GRR - Greater Rochester Robotics, from Churchville-Chili and Nortel Networks.
Posted on 2/7/2000 8:38 PM MST
We just finished testing our drive system and this works....
If you are looking for a quick and easy way to lock your drill gearbox in low or high gear try some O-rings. You'll need 2 per motor to get the correct width. They go in between the gears in the back half of the motor assembly case. I think we used 1-1/2 OD 1/8' wall.
Good luck. If you try it, let me know how you do with it.
-Team 340
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
Let the team grow, let them fail, let them learn and always be ready to lend a helping hand. I think that's the best way to help rookie teams. - Justin Montois [more] 
Threaded Mode