|
|
|
 At the end of the day, every team in FRC has accomplished something amazing in the sculpting of the next generation of leaders. - Elliot191 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| At the end of the day, every team in FRC has accomplished something amazing in the sculpting of the next generation of leaders. - Elliot191 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
03-02-2008, 09:28
|
|||||
|
|||||
|
Re: festo solanoid
Try blocking the exhaust port with a finger or loopback until your pneumatics system gains > 30psi.
The Festo pilot valve may be starting in a halfway or neutral state left over from the factory. The pilot valve requires a minimum of 30psi to shift properly and should normally be left in the home position where it automatically returns when powered down. Last edited by Mark McLeod : 03-02-2008 at 09:54. Reason: home |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Festo | itay_ms | Electrical | 3 | 30-01-2007 09:08 |
| Festo Single solenoid | JP_1163 | Pneumatics | 4 | 24-02-2006 15:07 |
| FESTO question | evilhunter | Programming | 8 | 30-03-2005 15:47 |
| festo solenoid | maxgebhardt | Pneumatics | 19 | 21-01-2004 23:06 |
| Festo Valve | Gary Bonner | Pneumatics | 2 | 26-02-2002 17:48 |
Threaded Mode