|
|
|
 FIRST has stated time and again that the program is not about teaching (they always refer to the I and R in FIRST) - Dave Flowerday [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST has stated time and again that the program is not about teaching (they always refer to the I and R in FIRST) - Dave Flowerday [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#20
04-02-2008, 09:24
|
|||
|
|||
|
Re: IR Board Fried?
There is an IR Receiver Breakout board available from SparkFun Electronics, all you would have to do is hook it up to a digital in on the main controller and program in the stream of bits. It would make the process a lot easer.
Board: http://www.sparkfun.com/commerce/pro...ducts_id=8554# I will post some example code later once I get mine setup. Erica Young 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| fried light | Robo_Coyote | General Forum | 8 | 21-02-2007 23:04 |
| Fried chicklet | karin l. | Control System | 5 | 24-01-2007 00:07 |
| Fried Cam? | Denz | Programming | 5 | 01-02-2006 21:43 |
| We fried an 884 | Andrew | Electrical | 13 | 17-08-2003 23:02 |
| fried | archiver | 2000 | 4 | 23-06-2002 22:45 |
Threaded Mode