Limit Sensors for Lift - Chief Delphi

and don't overestimate the ability of an unskilled fool with exotic tools! - MissInformation [more]

		Chief Delphi > Technical > Electrical
Limit Sensors for Lift

Thread Tools

Rate Thread

Display Modes

05-02-2008, 13:06

eugenebrooks eugenebrooks is offline

Team Role: Engineer

AKA: Dr. Brooks

no team (WRRF)

Join Date: Jan 2004

Rookie Year: 2001

Location: Livermore, CA

Posts: 601

eugenebrooks has a reputation beyond repute

Re: Limit Sensors for Lift

If your lift motor turns less than ten turns to go from
one end of the lift to the other, try a ten turn pot on
the shaft. It gives you a lot of position flexibility in
the software.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Time limit for animation????	gimpnub	3D Animation and Competition	24	22-02-2008 17:09
Scissort Lift vs. Crane vs. 4-Bar Lift vs. Gas Springs	AdamC	Technical Discussion	31	20-01-2008 18:49
Using a limit switch to limit motion	ManicMechanic	Programming	16	20-12-2007 00:54
Limit Switch for PCM	GeorgeC	Programming	4	16-02-2007 13:21
Limit on sensors	Gusman1188	Technical Discussion	13	16-02-2003 23:24

All times are GMT -5. The time now is 17:37.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.