field

[elvin23]

so if that is true your turn is? and what happens if its wide? i need measurements for that

[Vikesrock]

I'm going to be honest and say I'm not sure what exactly your asking for, but every measurement you could possibly want regarding the field is contained in or can be derived from the documents you were referenced to at first.

The general field layout can be found here:
http://www2.usfirst.org/2008comp/Dra...nd_Marking.pdf

As Eric said the Lane Divider goes in the middle of the long dimension leaving a roughly (very roughly) oval shaped track 13.5' wide all the way around the field.

[elvin23]

Originally Posted by Vikesrock

I'm going to be honest and say I'm not sure what exactly your asking for, but every measurement you could possibly want regarding the field is contained in or can be derived from the documents you were referenced to at first.

The general field layout can be found here:
http://www2.usfirst.org/2008comp/Dra...nd_Marking.pdf

As Eric said the Lane Divider goes in the middle of the long dimension leaving a roughly (very roughly) oval shaped track 13.5' wide all the way around the field.

you see where it says 2" tape white what are the measurements right there

[Vikesrock]

In the 27' direction (width) it is 13' 5.75" as noted in the drawing. in the 54' direction (length) it is approximately the same. If you build the lane divider according to the specs in the other documents and place the center of the lane divider at the center of the lane divider at the center of the long dimension (27' in on the 54' dimension), then the tape runs from the wall of the driver station to the lane divider.

[elvin23]

can you brake it down like a fraction

[Vikesrock]

In the 27' it is right in the middle (1/2). In the long direction (54'), it goes

Tape (1/4)
Divider (1/2)
Tape (1/4)