|
|
|
 Focus on solving the problem, not on being deliberately creative. If you effectively solve the problem, creativity is naturally leveraged as part of finding a great solution. - Jim Zondag [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
05-02-2008, 19:32
|
||||
|
||||
|
Re: Toughbox broken
We drilled our shaft with a 3/32" bit. Hammering the roll pin went much better. Not sure that Andymark would recommend this approach. But so far the gearboxes are working fine.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Toughbox Assembly | mjgard | General Forum | 39 | 16-01-2008 19:27 |
| Toughbox - Sketchup Model | Projectt2501 | CAD | 0 | 10-01-2008 21:24 |
| AM Toughbox Model(s) available | Ed Sparks | CAD | 2 | 08-01-2008 11:15 |
| Broken promises or BROKEN ROBOTS! | archiver | 1999 | 9 | 23-06-2002 22:18 |
Threaded Mode