Using the IR - Chief Delphi

#16

07-02-2008, 01:46

eugenebrooks eugenebrooks is offline

Team Role: Engineer

AKA: Dr. Brooks

no team (WRRF)

Join Date: Jan 2004

Rookie Year: 2001

Location: Livermore, CA

Posts: 601

eugenebrooks has a reputation beyond repute

Re: Using the IR

Your best bet would to be referencing the ground of the IR board directly to the ground of the digital inputs by connecting it there at the ports that you connect the signal pins to. One wire then runs to a 12 volt supply panel.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using the IR Receiver on the Robot	LG67	Control System	1	06-01-2008 01:42
Where do I begin to get the robot to move using the camera?	Ianuser	Programming	10	16-02-2007 17:55
Using the extra buttons on the joystick.	Code\\Pilot	Programming	7	04-12-2004 19:30
Rules for hanging, using a loop over the end of the bar	caffel	Rules/Strategy	10	04-06-2004 15:04
Is Anyone Using Motors to Hoist themselves off the platform on the bar?	xxlshortys	Motors	36	25-02-2004 01:06

All times are GMT -5. The time now is 02:35.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.