|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
|||||
|
|||||
|
Re: pic: Team 2404 (TNT) Omni Drive System
Wheels aside, I presume the C-channel things sticking up on all 4 sides are for bumper attachments? You would have a bolt of some form that comes out of the bumper and fits the slot on the channel, and then is tightened down.
My question is if you've checked the size of the frame. The channel adds a bit of width I think (can't tell for sure, but it looks wider than the end pieces of the kit frame). Beside that, there are bolt heads sticking out. A kit frame doesn't give you much leeway with the 28 inches - 3/8 or 5/8" as I recall. Check if you'll still fit in the box. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What drive system is your team using? | dpick1055 | Technical Discussion | 22 | 27-01-2007 23:29 |
| pic: One Omni wheel drive done | falconmaster | Extra Discussion | 2 | 11-01-2007 19:26 |
| pic: vex omni drive | 1902_Battery_SGT | FIRST Tech Challenge | 6 | 28-05-2006 17:55 |
| pic: Team 612 Drive System | RoboMadi | Robot Showcase | 7 | 08-02-2006 16:38 |
| pic: Omni Wheel Drive -- Top | Richard Wallace | Extra Discussion | 4 | 05-12-2005 18:55 |