Ball Knocker Advice

[MrForbes]

You might want to consider a hinged mechanism also....and if it has pneumatic actuation it will be kind of "springy" and might not need to be retracted to go under the overpass. also think about using a flexible part to knock the ball off.

We don't have any solid part of our robot extending past about 75" height, ever. We discovered that it really is not very difficult to knock the ball off. And catching it is the fun part....

[wilsonmw04]

We are working on our "ball popper" as well. We have a 24" throw piston to play with for actuation. We've run into two problems: 1. Where to place the device so that it won't tip us over when it strikes the overpass and where it won't interfere with our other device. 2. The Geometry of the ball makes punching it off the overpass a very interesting challenge. I guess this is the problem with putting something in as an after thought.

[MrForbes]

here's an example of knocking the ball off and catching it...

http://www.chiefdelphi.com/forums/sh...ad.php?t=63236

and I think there is video of it somewhere also, but I can't find that just now.

(they've reinforced the "twisty" parts since this picture was taken!)

[BenB]

Are you talking about hitting it off with some device, or actuating something and then running into the ball? Has anyone calculated approximate forces required to do either of these actions?

[MrForbes]

You could just run into the ball, I think 842 either runs into it or flips up the arm to hit it (ask them, they'll probably tell you). Try it, see what happens.

[Browzilla]

Originally Posted by 2166BlueBotics

Are you talking about hitting it off with some device, or actuating something and then running into the ball? Has anyone calculated approximate forces required to do either of these actions?

As of last night our plan was to have a 2" diameter pipe with a 1.5" pipe inside. Mount a pulley of some sort at the top to prevent cable wear and friction, and then increase the inches/sec by either attaching the winch spool to either a gear geared up to a better ratio or by using multiple pulleys.