|
|
|
 Sometimes, it takes years to gain respect and to learn to understand the opportunities that avail themselves to those who pay attention, are willing to learn from the best, and dig deeper into understanding what it means to be a competitive FRC team. - JaneYoung [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
programming
I recently downloaded the V7 master code with easy C V2. My robot will not go out of autonomous mode. If I put a jumper in interupter 6, it goes to operator control, however it does not exit out of autonomous mode under normal circumstances. I had the controller on when I tested this, and it still does not work. Please help. Thanks.
|
|
#2
08-02-2008, 20:55
|
|||
|
|||
|
Re: programming
I figured it out. Turns out I had the wrong version of the master code V7. It works now though.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming in Python and Explaination of Programming | roboxking | Programming | 22 | 07-01-2008 16:08 |
| programming motors with programming kit | BorisTheBlade | FIRST Tech Challenge | 4 | 01-11-2005 19:03 |
| Programming | Gusman1188 | Programming | 5 | 17-02-2003 11:23 |
| programming | great_one411 | General Forum | 0 | 15-02-2003 11:46 |
Linear Mode
