|
|
|
 A drag racer can have all the output torque in the world, but it does no good on ice. - Paul Copioli [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| A drag racer can have all the output torque in the world, but it does no good on ice. - Paul Copioli [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
09-02-2008, 10:32
|
||||
|
||||
|
Re: KOP Gear Tooth Encoder Trouble
I don't think it's my printf statement because I'm using kevin printf. and it's a con. zero.
The printf statment I made was to read the rc dig itself so I see if the variable is changing and since it's a dig input it can only change 0 to 1 and back again. the pwm connected is connected correctly. Any other guesses? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gear Tooth Sensor | marco_alchemy | Electrical | 7 | 06-02-2008 09:54 |
| Shaft encoder in KOP transmission? | MrForbes | Electrical | 7 | 24-01-2008 11:40 |
| Gear encoder code | Demothesis | Programming | 8 | 20-07-2007 17:15 |
| Gear Tooth Sensor Trouble | cprogrammer | Programming | 1 | 24-01-2006 13:48 |
| Turning a gear-tooth sensor into a quadrature output encoder | Jared Russell | Programming | 4 | 18-01-2006 22:19 |
Threaded Mode