|
|
|
 The goal isn't to keep the "bad" kids out. The goal is to take the "bad" out of kids, thereby transforming OUR culture. - Michael Corsetto [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The goal isn't to keep the "bad" kids out. The goal is to take the "bad" out of kids, thereby transforming OUR culture. - Michael Corsetto [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
02-10-2008, 02:09 AM
|
|||
|
|||
|
Re: 80" Cylinder Diameter Rule
Eugh, I hope this doesn't happen to us. We ran some calculations and it was close then, but after a bunch of design modifications we haven't run any more calculations since we're running out of time (we STILL haven't finished the manipulator, the most important part of the bot), and if we find out in the next week that we're outside our limit, it'll be too late to fix anything.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Parker 1-1/2" x 8" cylinder: Cost accounting | Manoel | Pneumatics | 2 | 02-12-2007 10:54 AM |
| Bending 2" diameter pipe/tubing | sanddrag | Technical Discussion | 12 | 05-11-2006 09:55 PM |
| 3/4" bore x 1/2" stroke Bimba Cylinder model | sanddrag | Inventor | 5 | 01-16-2006 10:14 PM |
| "Thunderbirds" Vs. "Team America" Which one will rule the box office? | Elgin Clock | Chit-Chat | 3 | 09-07-2004 07:53 PM |
| 2" Pneumatic Cylinder Posted | Ed Sparks | General Forum | 0 | 01-27-2002 03:47 PM |
Threaded Mode