|
|
|
 If you have time at a competition, stop and thank some of the people wearing the crew shirts. They are working very hard to make sure the competition goes as smoothly as possible. - Greg Young [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: pic: BTW-1209 hurdling robot
we are using 2020 (8020 is the brand name) as well and i believe i saw the video you had of your lift on you tube and it is essentially the same as ours but we are using two pillars of 2020 with a section in the center for our claw
yours looks like its WAY lighter than ours (we have about 7lb right now to finish making edits and then we will have to start swiss cheesing) but also looks a little structurally unsound... 
|
|
#2
10-02-2008, 13:12
|
||||
|
||||
|
Re: pic: BTW-1209 hurdling robot
You should probably set your lift so that there is more overlap between sections. This will increase the strength dramatically as well as reduce friction.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: hurdling | falconmaster | Extra Discussion | 7 | 04-02-2008 08:23 |
| Hurdling | SSMike | Rules/Strategy | 3 | 19-01-2008 13:21 |
| hurdling | daftpunk79 | General Forum | 5 | 08-01-2008 20:06 |
| Hurdling | akash155 | Rules/Strategy | 3 | 05-01-2008 23:50 |
| summer coming... need job!!! btw, who's coming to Berkeley? | archiver | 2001 | 0 | 24-06-2002 03:46 |
Hybrid Mode
