HALP I Need IR Board Firmware!

If you're a spectator that's going to complain about a "bad" call, you darn well better know for a FACT that the call was "bad". - AmyPrib [more]

		Chief Delphi > Technical > Control System > Sensors
HALP I Need IR Board Firmware!

Thread Tools

Rate Thread

Display Modes

10-02-2008, 15:09

jgannon

I ᐸ3 Robots

AKA: Joey Gannon

no team

Join Date: Feb 2004

Rookie Year: 2004

Location: Pittsburgh, PA

Posts: 1,467

Re: HALP I Need IR Board Firmware!

You can contact the designer of the board, Bob Grieb, at rlgrieb@verizon.net and see if he can help you.

__________________
Team 1743 - The Short Circuits
2010 Pittsburgh Excellence in Design & Team Spirit Awards
2009 Pittsburgh Regional Champions (thanks to 222 and 1218)
2007 Pittsburgh Website Award
2006 Pittsburgh Regional Champions (thanks to 395 and 1038)
2006 Pittsburgh Rookie Inspiration & Highest Rookie Seed

Team 1388 - Eagle Robotics
2005 Sacramento Engineering Inspiration
2004 Curie Division Champions (thanks to 1038 and 175)
2004 Sacramento Rookie All-Star
_

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need an IR Board?	Pavan Dave	General Forum	1	10-02-2008 14:33
HALP! autonomous I am lose	Shadow_Cat	Programming	4	31-01-2008 21:37
Need tips on wiring the IR board	Bryan Herbst	Control System	4	12-01-2008 18:34
TTL CMUcam2 2004 eduRC bug... HALP PLZ	ruddy	Electrical	3	21-12-2007 22:26
RC Firmware	JoeFryman	Programming	1	12-02-2005 12:54

All times are GMT -5. The time now is 20:03.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.