|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Need help with IR as an Input
we put power too the board.
now when we go to wire the IR board to the digital inputs of the RC controller..... we wire the output from the IR to the signal pin of the digital input (the white wire) ......now what? |
|
#2
|
|||
|
|||
|
Re: Need help with IR as an Input
Wire a ground cable from your robot's ground to the ground pin on the digital I/O.
|
|
#3
|
||||
|
||||
|
Re: Need help with IR as an Input
ground as in the terminal block, the fuse panel, or the ground on the ir
|
|
#4
|
|||||
|
|||||
|
Re: Need help with IR as an Input
Now have your program read the values on the digital inputs and take appropriate action when exactly one of them is active. Assuming your power to the board is coming from a 20A breaker on the main black breaker panel, it sounds like the wiring you described is correct.
(If you haven't done so already, first follow the directions in the FIRST IR User Guide to train it to recognize commands from a remote control.) |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I need help with plastics | mechanicalbrain | Technical Discussion | 13 | 14-06-2006 11:15 |
| Need help with beacons | magical hands | Programming | 2 | 11-02-2004 21:48 |
| hey need some help with writing a code please help me here | magical hands | Programming | 9 | 01-01-2004 21:46 |
| Need help with C++ | Tton | Programming | 7 | 04-11-2003 19:15 |
| Need help with controller | Devil's Kid | Technical Discussion | 6 | 20-01-2002 21:47 |