|
|
|
 I looked at it and originally thought it was a crazy idea... then I looked at it again and it still sounds like a crazy idea. But crazy ideas tend to produce some excellent results. - Yipyapper [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
11-02-2008, 15:14
|
|||||
|
|||||
|
Re: IR board wiring
Red is +5v, black is ground, white is signal...so you probably want to connect each of the IR board outputs to the white wire connection of one digital input on the RC, and connect the IR board ground to a black wire.
This could be done by cutting the male end off of 4 PWM cables and splicing the wires on the ribbon cable from the IR board to the PWM cables that have the end that will plug into the RC. Use solder to splice the wires, and heat shrink tubing to cover the splice. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wiring IR board | DarKCroNo | Sensors | 3 | 09-02-2008 10:20 |
| Wiring the IR sensor board | govvijay | Programming | 9 | 05-02-2008 19:41 |
| Need tips on wiring the IR board | Bryan Herbst | Control System | 4 | 12-01-2008 18:34 |
| pic: Team 668 Wiring Board | burkechrs1 | Extra Discussion | 4 | 06-02-2007 01:56 |
| Perf Board = BS2-IC Carrier Board? | indieFan | Electrical | 2 | 16-09-2004 08:28 |
Threaded Mode