|
|
|
 Sometimes, you just have to beat something (someone?) into submission. Yes, you can use your head, but its a lot easier with a hammer. - Andy A. [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Sometimes, you just have to beat something (someone?) into submission. Yes, you can use your head, but its a lot easier with a hammer. - Andy A. [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Ideas on how to program automatically aligning motors
Hello, I was wondering if there's somebody who could help me with my problem, I need ideas on how I could program so the motors could automatically align our wheels.
|
|
#2
11-02-2008, 16:54
|
|||||
|
|||||
|
Re: Ideas on how to program automatically aligning motors
You could use the gear tooth sensors provided in the kit to measure the speed of the wheels or output shaft or any gear on both sides and adjust it accordingly to make it the same.
|
|
#3
11-02-2008, 17:10
|
||||
|
||||
|
Re: Ideas on how to program automatically aligning motors
Our code team has created functions that basically uses a quadrature enocoder attached to both drive wheel axis to read the speed of the motor. We then use a PID loop to adjust the motor speed appropriately. We're testing the code now. Once we get it all worked out I'll see if I can post it here.
 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to conect solenoids to the circuit board. and how to program it...??? | arpitshah | Pneumatics | 6 | 13-01-2008 15:06 |
| Ideas on how to do something... | 1908Robotics | Technical Discussion | 13 | 05-01-2008 22:34 |
| pic: Chain Aligning #1564 | Dave_Lu | Extra Discussion | 7 | 02-04-2006 17:38 |
| Pneumatics Extend Automatically | Joshua May | Pneumatics | 4 | 02-04-2005 01:02 |
| Motors.. and more motors.. How many on your 2004 bot? | OneAngryDaisy | Motors | 33 | 23-02-2004 00:46 |
Linear Mode
