|
|
|
 CD would not be what it is without Brandon - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| CD would not be what it is without Brandon - Richard Wallace [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
11-02-2008, 21:41
|
||||
|
||||
|
Re: Please Help need quick answer :)
The robot controller's digital pins are pulled high internally. In order to make the pressure switch work, you need only connect the ground and signal wires of the PWM cable to the two screws on the pressure switch. Cap the red +5v wire and don't connect it to anything.
Furthermore, the safety valve and pressure switch are two different things. The safety valve should let air out of the system when the pressure exceeds 125 PSI. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Please Only Answer Questions if you know the Answer! | Greg Needel | General Forum | 30 | 18-02-2010 12:26 |
| Need an answer super quick, keyang motors!!! | R.C. | Motors | 8 | 16-02-2008 18:40 |
| Need a quick answer about grabber.... | Steven S | Technical Discussion | 5 | 10-02-2008 17:02 |
| Need a quick answer!!!! | latonya | Motors | 1 | 09-02-2008 18:22 |
| Need some quick help, ASME scholarship! | Hymnson | General Forum | 2 | 25-02-2002 16:07 |
Threaded Mode