|
|
|
 If only we could have Week 6 urgency every week. - Gray Adams [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If only we could have Week 6 urgency every week. - Gray Adams [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Hooking up a custom OI panel
We are planning a panel of switches for our pneumatics, but might have a problem. I found the pinout guide at http://www.chiefdelphi.com/media/photos/26381 and it looks like there are only 4 digital outputs; we are needing eight. We could hook up a second serial connector, but I was wondering if the analog outputs could be used. I'll admit I am mostly a programming guy, so this may be an incredibly stupid question.
I know the analog outputs have a range of 0-255. If we hooked up our on off switch to them, would they return 0 or 255, depending on the switch position, or would they fry our OI? I'm hoping I can be lazy without killing anything. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hooking up a backup battery | neoshaakti | Control System | 7 | 26-01-2008 22:09 |
| hooking up potentiometers | chippermonky | Programming | 1 | 05-02-2007 20:04 |
| Hooking up 2 Servos | kutty18 | Programming | 7 | 04-02-2005 09:26 |
| Problems hooking up a joystick to edubot | Salik Syed | Programming | 2 | 24-03-2004 23:56 |
| hooking up sensors to controller? | Oakridege_665 | Technical Discussion | 5 | 21-01-2002 14:55 |
Threaded Mode