|
|
|
 Honestly, just when I thought FIRST had finally created an FRC game without any near universally-hated rules, they went ahead and made one in TM 1. - artdutra04 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Honestly, just when I thought FIRST had finally created an FRC game without any near universally-hated rules, they went ahead and made one in TM 1. - artdutra04 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
DeWalt Transmission Problem
Our team recently purchased two brand new DeWalt transmissions and interfaced them with the KOP globe motors. One Drives a belt and the other drives a chain with idlers at the bottom. They are both attached to arm fixtures, one with minimal weight and the other with a substantial ammount of weight. The transmissions work great lifting our the armatures, however when letting them down they tend to jump. The transmission attached to the lighter weight jumps almost un-noticeably. The larger one however will not turn when the torque is set to one and jumps once then breaks the torque when set to 21. We have tried surgical tubing to relieve the weight from the transmission, however when it gets towards the top and the tubing slacks we have the same problem.
Has any other team experienced this problem? How did you solve It? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drawings/Model of DeWalt Transmission | sanddrag | Inventor | 30 | 23-12-2008 19:01 |
| quick dewalt transmission dissasembly question | Ryuzaki | General Forum | 2 | 11-01-2008 01:49 |
| DeWalt Transmission questions | StevenB | Technical Discussion | 22 | 14-02-2007 16:02 |
| Dewalt transmission problems? | roach1051 | Technical Discussion | 10 | 11-04-2006 00:33 |
| DeWALT Transmission After Action Report | CyberWolf_22 | Technical Discussion | 7 | 17-04-2005 00:28 |
Threaded Mode