|
|
|
 The gearbox can be anything, just as long as it weighs less than 0 lbs, and yes, I'm talking about negative weight here. - NoodleKnight [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| The gearbox can be anything, just as long as it weighs less than 0 lbs, and yes, I'm talking about negative weight here. - NoodleKnight [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#17
13-02-2008, 01:47
|
||||
|
||||
|
Re: Using the IR
do I have to use two wires each for both ground and power? or can i just use the wires that correlate to pin 1 and 3 ?
thanks 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using the IR Receiver on the Robot | LG67 | Control System | 1 | 06-01-2008 01:42 |
| Where do I begin to get the robot to move using the camera? | Ianuser | Programming | 10 | 16-02-2007 17:55 |
| Using the extra buttons on the joystick. | Code\\Pilot | Programming | 7 | 04-12-2004 19:30 |
| Rules for hanging, using a loop over the end of the bar | caffel | Rules/Strategy | 10 | 04-06-2004 15:04 |
| Is Anyone Using Motors to Hoist themselves off the platform on the bar? | xxlshortys | Motors | 36 | 25-02-2004 01:06 |
Threaded Mode