Using the IR - Chief Delphi

IRI seeks to invite the very best robots to play the FIRST game, achieving the highest level of play, while keeping in place the FIRST atmosphere. - Nathan Streeter [more]

		Chief Delphi > Technical > Control System > Sensors
Using the IR

Thread Tools

Rating:

Display Modes

#18

13-02-2008, 02:08

eugenebrooks eugenebrooks is offline

Team Role: Engineer

AKA: Dr. Brooks

no team (WRRF)

Join Date: Jan 2004

Rookie Year: 2001

Location: Livermore, CA

Posts: 601

eugenebrooks has a reputation beyond repute

Re: Using the IR

Quote:

Originally Posted by neoshaakti

do I have to use two wires each for both ground and power? or can i just use the wires that correlate to pin 1 and 3 ?
thanks

There is no requirement to use two power and two ground
connections. Also, according to team updates, you can modify
the board to run off of the 5 volt rail by removing the voltage
regulator and installing the jumper across the pads provided for
this purpose. By doing this the power and signal wires can terminate
on the digital input rail of the RC with no extra wiring to the 12
volt supply.

Eugene

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using the IR Receiver on the Robot	LG67	Control System	1	06-01-2008 01:42
Where do I begin to get the robot to move using the camera?	Ianuser	Programming	10	16-02-2007 17:55
Using the extra buttons on the joystick.	Code\\Pilot	Programming	7	04-12-2004 19:30
Rules for hanging, using a loop over the end of the bar	caffel	Rules/Strategy	10	04-06-2004 15:04
Is Anyone Using Motors to Hoist themselves off the platform on the bar?	xxlshortys	Motors	36	25-02-2004 01:06

All times are GMT -5. The time now is 12:53.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.