|
|
|
 Are they Robots? Of course they aren't robots; they are obviously and unambiguously robots. - gblake [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Are they Robots? Of course they aren't robots; they are obviously and unambiguously robots. - gblake [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
Electronics Board Wiring Concern
 When i saw that we needed 6 Victors i became concern of where to ground them all. the First Wiring Diagram indicated to route them into the distribution block at the top. Since at the time we didnt think we would have enough space for 6 or more grounds we instead routed a single black 6AWG GND wire to the ATC fuse Block and then connected to the Victor Grounds from there. (blue wires) How would a judge feel about this? is it fine, or is rerouting needed? Last edited by SpaceOsc : 13-02-2008 at 04:09. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ABS Electronics Board | Ian Curtis | Electrical | 3 | 07-01-2008 23:25 |
| pic: Top of electronics board | keenanmolner | Extra Discussion | 4 | 19-02-2007 00:57 |
| pic: Side of electronics board | keenanmolner | Extra Discussion | 1 | 18-02-2007 20:15 |
| pic: practice electronics board | sonofdad123 | Extra Discussion | 5 | 23-01-2007 21:01 |
| pic: 1023 Electronics Board | KTorak | Robot Showcase | 1 | 13-02-2006 21:57 |
Threaded Mode