Creating hex file help

[1213]

Well actually we have two questions to ask.
First, we can't seem to make our robot work with both a gyro and default code. It can work with one or the other, but not together.
Secondly, we can't seem to make a hex file that will work.

This is the error we get when we try to build our the gyro code from kevin.org in MPLab:
Thread would not exit normally. Process would not exit normally. Could not read language tool output from pipe (5). A Language plug in occurred and was logged. Build Failed.

we are using MPLab v 8.0

[Racer26]

You should be using the MPLAB and C18 Compiler provided to you in your Kit of Parts. I believe this is MPLAB v7.2, if I'm not mistaken. You may also wish to read up on how the C language works, so you gain understanding of how to merge the two codes. Also, You may find that EasyCPRO, as provided to teams by intelitek, is better suited to your (seemingly inexperienced) programming team.

[Shivang1923]

v8.0 wont work... You HAVE to have 7.2 I made the mistake...took our team about a week to figure it out