|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
|
|||||
|
|||||
|
Re: COMPRESSOR & PRESSURE SWITCH HELP...
Add
Code:
relay7_rev = 0; These answers assume you are using MPLAB w/IFI or Watson default code. What are you using? Tell us what is happening. --Is the compressor turning on, but not off? --What color is the compressor Spike light? --Is your pressure switch wired with only the ground and signal lines (black & white usually), NOT the red wire? --Is the Spike fuse replaced with a 20a snap-action breaker? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programing the compressor and pressure switch in easy C | Mr Monte 83 | Programming | 1 | 30-01-2008 15:39 |
| [OCCRA]: Problem with the compressor, pressure switch, or Bosch relay. | BrittanyV | OCCRA | 3 | 16-10-2006 15:42 |
| Urgent need for Nason pressure switch!! PLEASE HELP! | haverfordfords | Pneumatics | 12 | 18-02-2005 02:04 |
| HELP US PLEASE?!?!(pressure switch code) | kingpin3787 | General Forum | 1 | 21-02-2004 15:13 |
| NEED HELP with Delay loop for compressor relay switch | archiver | 2001 | 10 | 24-06-2002 02:11 |