|
|
|
 I don't remember who said it or what the words are exactly...(I think it was Hopalong Cassidy) Don't say goodbye, just say see you later. - Al Skierkiewicz [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I don't remember who said it or what the words are exactly...(I think it was Hopalong Cassidy) Don't say goodbye, just say see you later. - Al Skierkiewicz [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#7
17-02-2008, 00:31
|
|||||
|
|||||
|
Re: Metal Spur gear for Keyang motors
Your question clarifies the reason why this is (unless Q&A says otherwise, which I doubt they will) okay... you are replacing a part of the GEARBOX that is ATTACHED to the motor.
You could, theoretically, hack off the entire worm gear mechanism and just use the motor component of the Keyang, just as you are under no obligation to use the plastic gearbox that came with the FP motors. (And, in fact, I highly recommend you don't... banebots has many excellent alternatives!) Jason NOTE: Jim's post, below, quotes the rule and has me wondering whether I went a bit too far with my surety that the Q&A will be favourable... but go ahead and ask, anyway. Last edited by dtengineering : 17-02-2008 at 00:45. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Keyang Motor Spur Gear Pitch | Dan Petrovic | Technical Discussion | 4 | 24-01-2012 21:35 |
| Power connections for Keyang motors | aeasson | Motors | 7 | 16-02-2008 18:35 |
| Looking for Keyang Window Motors | Riley | Motors | 0 | 13-02-2008 16:20 |
| Spur gear to go CIM for 56mm Banebots | John Gutmann | Motors | 5 | 30-05-2007 13:45 |
| Where to terminals for KEYang motors? | steve d | Electrical | 1 | 09-02-2007 08:09 |
Threaded Mode