|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
|||||
|
|||||
|
Re: CIM Pinion issues in Toughbox
That makes sense... if the key was longer then the clip could have been pushed down over it, thus allowing it to sneak out as you drove.
The fix you have posted sounds pretty much foolproof, though, and fortunately it happened at a time when you had time to investigate and repair. About our only "discovery" so far has been that unless the compressor is very well supported and restrained, that those little rubber vibration dampers shear off quite easily in a high-speed impact with a cement wall.... even with bumpers on. Okay... after SEVERAL high-speed impacts with a cement wall. Jason |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Toughbox broken | Evert | Kit & Additional Hardware | 5 | 05-02-2008 23:43 |
| Toughbox Assembly | mjgard | General Forum | 39 | 16-01-2008 19:27 |
| AM Toughbox Model(s) available | Ed Sparks | CAD | 2 | 08-01-2008 11:15 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| Converting the Bosch Metric Pinion into an English- Specification Pinion | evolution | Motors | 3 | 28-08-2004 16:30 |