|
|
|
 Build tough and come to play. - JaneYoung [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Build tough and come to play. - JaneYoung [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
17-02-2008, 22:41
|
||||
|
||||
|
Re: Connecting IR Board
The IR board will have four connections to the RC, one for each of the signals. The exact pins those signals are from can be found in the IR board manual. You will need to use a minimum of two PWM cables to hook up the four pins. One can go across three sensor pins, and another can fit normally.
Programming would depend on what application you're using. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| connecting sensors | guy_rom | Electrical | 4 | 01-02-2008 13:21 |
| Connecting LCD module to RC | David55 | Electrical | 5 | 13-07-2006 22:09 |
| Lights in Joystick board or control board | rcubes85 | Control System | 15 | 26-02-2005 23:40 |
| Connecting Switch to RC | Mr. Steve | Control System | 2 | 28-01-2005 22:37 |
| Perf Board = BS2-IC Carrier Board? | indieFan | Electrical | 2 | 16-09-2004 08:28 |
Threaded Mode