|
|
|
 I think that FIRST should just give up and officially recognize Chiefdelphi as the place to go for community and team resources. - Greg Needel [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I think that FIRST should just give up and officially recognize Chiefdelphi as the place to go for community and team resources. - Greg Needel [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
18-02-2008, 04:55
|
||||
|
||||
|
Re: Can one PWM control 2 Victors for Tandem Motors
In short the answer is yes and yes. You can run the yellow "Y" cable from one pwm port to two victor speed controllers. This is something that we have done for years with our drive system. Also rev e would take precedence over any updates that came out before it, if there are any rules that contradict each other that is.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using two motors in the tandem | Tom Line | Motors | 11 | 20-03-2007 09:20 |
| PWM, victors and motors | SoD | Programming | 3 | 31-01-2007 12:24 |
| "Backdriving" Motors -- Safe for Victors? | Ken Streeter | Electrical | 6 | 20-01-2007 14:02 |
| victors spikes and pwm cables | sburro | Electrical | 3 | 23-02-2005 02:24 |
| PWM Cable Clip for Victors | sanddrag | Technical Discussion | 9 | 18-07-2004 19:27 |
Threaded Mode