|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Wiring 2 CIM motors to one Victor
We do this as well ... one motor per Victor. A "Y" PWM cable (the black-red-yellow one of which 2 are supplied in KOP) goes from ONE PWM output on the Robot Controller to both Victors.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| Cim motors | trhgammer | Motors | 1 | 15-02-2006 12:31 |
| CIM Motors | UlTiMaTeP | Motors | 13 | 10-01-2006 14:48 |
| 6 CIM Motors? | psquared89 | Kit & Additional Hardware | 16 | 09-01-2006 08:47 |
| CIM Motors | rocky ali | Motors | 2 | 24-09-2005 17:55 |