|
|
|
 And then, at the end of the match, the drive teams who are being lifted all say at once (in a GOVERNATOR voice)- "GET TO ZE CHOPPER!!!" - Graham Donaldson [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Problem with 2008 gear tooth sensor
The bad one is the end board on the sensor strip. The good one is the next one in. If you have already separated your boards (and I'm thinking that by now you should have) the board with one smooth edge is the bad one and the one with 2 small nibs on opposite edges is the good one.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gear Tooth Sensor | marco_alchemy | Electrical | 7 | 06-02-2008 09:54 |
| Help with Gear Tooth Sensor | RedOctober | Electrical | 3 | 27-01-2006 18:38 |
| Gear Tooth Sensor | Talha | Electrical | 1 | 23-01-2006 21:29 |
| gear tooth sensor connecting problem | nirty | Electrical | 2 | 23-01-2006 12:17 |
| Gear Tooth Sensor | AMIRAM | Electrical | 2 | 22-01-2006 04:09 |
Hybrid Mode
